1. All Workers to be Properly Protected in PPE Equipment, Gloves, Tyvek Suits, Respirators, etc.
2. Set-up critical barriers to prevent cross contamination to structure and also achieve negative air.
3. All openings such as doorways, windows, vents, airways to be covered with 6 mil-poly. This will insure negative air can be maintained. Full containment.
4. Set-up Negative Air Machine to minimize airflow 4 to 8 ACH (air changes per hour).
5. Pre-clean (HEPA vacuum) structure and remove all loose structural debris in doubled (6-Mil) sealed plastic bags.
6. The use of electric blower inside each containment area to suspend fine particulates so that they
are captured by a HEPA filter.
7. Demolition of contaminated structure, then double bagged and removed to dumpster daily.
8. Scrape, wire brush, orbital sanding, Media and or Dry ice blasting to remove any visible mold growth from structural materials.
9. HEPA vacuum, biowash(wet wipe) then HEPA vacuum 2nd time (dust free environment). Clean
and encapsulate any structure members affected by mold. (organic surfaces)
10.HEPA vacuum, double bag and remove all unsalvageable contents to dumpster.
11.Preclean salvageable contents (HEPA vacuum)
12.HEPA vacuum, wet wipe with biowash. Then HEPA vacuum all contents again.
13.Removal of all personal possessions as well as soft goods, i.e. clothing, bedding, curtains etc.
Clothing may be cleaned using standard laundering products.
14.Maintain Negative Air Machine and Air Scrubbers throughout course of job.
15.HEPA Air filtration to run for a minimum of 72 hours after abatement is completed, and then shut
down for a minimum of 24 hours before post remediation testing.
16.Break down of containment barriers